Two-way control
Commands
Send parameters to any node. Values are validated client-side, then written over the LAN.
DC Bus
645.0V
Motor Current
38.4A
Output Freq
48.7Hz
Heatsink Temp
72.4°C
Power
18,420.0W
Motor Speed
1,456.0rpm
Quick commands
Preset writes — the page computes the register offsets, the device only sees the value.
Set Output Frequency
Adjusts the motor drive speed reference.
Voltage Reference
Sets supply voltage setpoint.
Start sequence
Triggers the configured start-up recipe.
Soft stop
Ramp down to zero, preserving recipe state.
Reset faults
Clears non-critical faults (operator authority required).
Start calibration
Puts the device into maintenance mode for calibration.
Recent writes
Audit trail — last 12 commands
00:24VFD-03Set Output Frequency → 50.0 Hz@mr1970
00:18PWR-10Set Demand Limit → 480 A@mr1970
00:09WLD-04Set Gas Flow → 14.0 L/min@k.moradi
11:42CMP-06Set Target Pressure → 8.0 bar@mr1970
11:20HMI-07Acknowledge WO-4412@h.ahmadi
10:58FRN-05Recipe R-2284 → Start@mr1970
10:31HMI-07Auto calibration → Touch HMI@system
09:14WLD-04Set Wire Feed → 8.4 m/min@k.moradi
08:48CON-08Set Speed → 1.5 m/s@mr1970